ASSRA Forum › General › Single Shot Rifles › Ballard Pacific inlay
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Ballard Pacific inlay (Read 322 times)
kootne
Senior Forum Member
****
Offline



Posts: 456
Location: Libby, Mt.
Joined: Mar 6th, 2012
Re: Ballard Pacific inlay
Reply #15 - yesterday at 7:37pm
Print Post  
That inlay was originally horn, I am pretty sure all of those vee shaped inlays on Ballard forearms, and pistol grip stocks along with the forend caps were horn.
  
You can't make good decisions without good information.
Back to top
 
IP Logged
 
westerner
Frequent Elocutionist
*****
Offline


deleted posts and threads
record holder.

Posts: 12007
Location: Why, out West of course
Joined: May 29th, 2006
Re: Ballard Pacific inlay
Reply #16 - yesterday at 9:29pm
Print Post  
Horn sounds right. Is that horn?
  
A blind squirrel runs into a tree every once in a while.
Back to top
 
IP Logged
 
westerner
Frequent Elocutionist
*****
Offline


deleted posts and threads
record holder.

Posts: 12007
Location: Why, out West of course
Joined: May 29th, 2006
Re: Ballard Pacific inlay
Reply #17 - yesterday at 10:00pm
Print Post  
TomKlinger wrote yesterday at 7:16am:
Westerner,
Maybe someone damage the stock somehow at the ramrod hole and repaired it with an inlay. 

Tom Klinger


I think you're right, Tom. Looked inside and see bedding compound. Looks sorta like Microbed. Would still like to see other Pacifics with the inlay.
  
A blind squirrel runs into a tree every once in a while.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1323 seconds.