ASSRA Forum - bullet for CPA 38-50 silhouette rifle

ASSRA Forum › General › Single Shot Rifles › bullet for CPA 38-50 silhouette rifle

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1 2 [3]

bullet for CPA 38-50 silhouette rifle (Read 2608 times)

SSShooter Frequent Elocutionist Offline Posts: 2941 Location: Southern NJ Joined: Aug 1^st, 2010	Re: bullet for CPA 38-50 silhouette rifle Reply #30 - yesterday at 1:57pm	Print Post
	Based on one of the comments above about thinking the bullet my not be optimally aligned with the bore axis when the action is closed, I used a set of neck bushing dies for my 38-50 from CH4D as the last step in loading. Doing so did a good job of removing the bullet 'run out' (a big deal in the land of high power benchrest) and aligning to the bore axis. That said, my 0.366x0.375 Bartlein barrel liked the 365gr BACo Creedmoor bullet better than their 360gr Money bullet - Jim cut both molds to my spec's for my tight barrel dimensions. They cast at 359gr & 356gr in 16-1 for me.

	Glenn - Stevens 044 1/2, Bartlein SS 5R barrel in 22LR
	GTalk IP Logged

gunlaker Frequent Elocutionist Offline Posts: 2565 Location: lower mainland, B.C. Joined: Dec 13^th, 2010	Re: bullet for CPA 38-50 silhouette rifle Reply #31 - yesterday at 2:44pm	Print Post
	Glenn I had no idea that CH4D mde neck bushing dies that I could use with my 38-50. I'll have a look into that. Currently my dies size the brass down more than I'd like, and the expander definitely adds a ton of runout. As a result the only way I've been able to get it to shoot half decently is with slip fit bullets. Nothing wrong with slip fir of course, but the dimensions of my original money bullet aren't ideal for that. The new one I have will work better as far as alignment goes. The tough part is that I have no idea how long it'll be before I can get to the range again.


	IP Logged

Pages: 1 2 [3]

‹ Previous Topic | Next Topic ›

Page completed in 0.4377 seconds.