ASSRA Forum › General › General Discussion › 58 CF rolling block
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) 58 CF rolling block (Read 896 times)
1Hawkeye
Full Member
***
Offline



Posts: 188
Location: South end of Northern Virginia
Joined: Jun 29th, 2019
Re: 58 CF rolling block
Reply #15 - Oct 28th, 2025 at 8:34am
Print Post  
I got a lyman mold awhile back that didn't have the pin. Lyman replaced the pin for 30.00 shipped but I had to send the mold back to them to have the pin fitted.
  
Back to top
 
IP Logged
 
RonnieMilsurp
Participating Member
*
Offline



Posts: 19
Joined: Feb 25th, 2024
Re: 58 CF rolling block
Reply #16 - Oct 29th, 2025 at 9:32pm
Print Post  
Interesting. Accurate could make a custom one but would have to supply a pin for the base as they do not. I suppose I could commission a pin from a machine shop? I still don't have a lathe, unfortunately.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7980 seconds.