ASSRA Forum › General › Reloading the Single Shot Rifle › Stuck Bullet Mold
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Stuck Bullet Mold (Read 1182 times)
Skalkaho
Oldtimer
*****
Offline



Posts: 821
Location: Montana
Joined: Sep 29th, 2006
Re: Stuck Bullet Mold
Reply #15 - Jul 30th, 2025 at 9:27am
Print Post  
When cleaning lead off a mold using a piece of black walnut.I see no reason to not do same here?  Heat the mold with torch and let all the lead run out and scrap away with the charred wood  and work it out. slow but sure...you wont scratch the mold using the walnut ....
  
May the Bullet Gods be with you.......
Back to top
 
IP Logged
 
Tom_Trevor assra life no.71
Oldtimer
*****
Offline


Tom Trevor

Posts: 708
Location: Granada Hills Ca.
Joined: Jun 16th, 2004
Re: Stuck Bullet Mold
Reply #16 - Aug 2nd, 2025 at 12:16pm
Print Post  
flatlander, Did you get it out and how? Have you cast again and what was the result? I think many of us would like to know.
  
Back to top
 
IP Logged
 
Flatlander
Oldtimer
*****
Offline



Posts: 646
Location: Warm Arizona
Joined: Apr 24th, 2004
Re: Stuck Bullet Mold
Reply #17 - Aug 7th, 2025 at 12:16pm
Print Post  
Tom_Trevor assra life no.71 wrote on Aug 2nd, 2025 at 12:16pm:
flatlander, Did you get it out and how? Have you cast again and what was the result? I think many of us would like to know.

See reply #13. Any other questions please ask. Took small ridge of metal off offending block face.  I have never seen a block casting this stuck. Have not used it yet to make sure everything is okay.
Flatlander
  
NRA Life
ASSRA Member 3197
Charcoal Burner
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.8347 seconds.