ASSRA Forum › General › General Discussion › New Scope Question
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic New Scope Question (Read 464 times)
cheatin_charlie
Senior Forum Member
****
Offline



Posts: 389
Location: ohio
Joined: Jan 10th, 2009
New Scope Question
May 16th, 2025 at 5:55pm
Print Post  
On a Lyman super target spot scope can a person remove the parallax adjustment sleeve to clean and rubricate the threads without screwing something up?  Mine feels like the lube is dried out.
  
Back to top
 
IP Logged
 
nuclearcricket
Oldtimer
*****
Offline



Posts: 805
Joined: Oct 15th, 2008
Re: New Scope Question
Reply #1 - May 16th, 2025 at 7:00pm
Print Post  
Yes, the front lock ring/sunshade unscrews and then the adjustment sleeve unscrews.  The lens holder will have to be carefullly pulled out. The hard part is putting the lens holder back in. There is a very small tit that the lens holder has to align with so it slide back in. Its hard to see but you can feel it with your finger. 
Sam
  
Back to top
 
IP Logged
 
cheatin_charlie
Senior Forum Member
****
Offline



Posts: 389
Location: ohio
Joined: Jan 10th, 2009
Re: New Scope Question
Reply #2 - May 16th, 2025 at 7:18pm
Print Post  
Thanks feels like tar instead of lube on threads and lens holder.  Charlie
 
Thank you I took it apart and cleaned it, oiled it and works like it should.
« Last Edit: May 17th, 2025 at 4:27am by cheatin_charlie »  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7736 seconds.