ASSRA Forum › General › General Discussion › MVA tang sight
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic MVA tang sight (Read 237 times)
nuclearcricket
Oldtimer
*****
Offline



Posts: 759
Joined: Oct 15th, 2008
MVA tang sight
Dec 16th, 2024 at 8:50am
Print Post  
Not quite sure where to put this questions but figured this would be probably the safest place. I have an an origional low wall in 38 wcf and am in need of a rear sight. It seems that finding a proper barrel sight is expensive and a bit on the scarce side. That being said I am considering one of the MVA copy's of the Lyman tang sight. I am well aware of the quality of their target tang sights and was wondering if anyone had any experience with their Lyman copy's, good bad or other wise.
TIA
Sam
  
Back to top
 
IP Logged
 
Smoke
Oldtimer
*****
Offline



Posts: 710
Location: San Diego
Joined: Feb 24th, 2013
Re: MVA tang sight
Reply #1 - Dec 17th, 2024 at 11:19am
Print Post  
Haven't used the Lyman copy from MVA but have used the Marbles version.  A bit less money and it has windage.
  
Back to top
 
IP Logged
 
oneatatime
Frequent Elocutionist
*****
Offline



Posts: 3915
Location: Rocky Mountains
Joined: Oct 30th, 2011
Re: MVA tang sight
Reply #2 - Dec 17th, 2024 at 1:11pm
Print Post  
If you plan on shooting it in matches, get a new real Marbles. Easy to tell where it is set and easy to make minor adjustments to elevation and windage and you can send me the $100 difference;-)
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4072 seconds.