ASSRA Forum - 25-20 ss

ASSRA Forum › General › Reloading the Single Shot Rifle › 25-20 ss

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Page Index Toggle

Pages: 1

Normal Topic

25-20 ss (Read 519 times)

wildthing Junior Member Offline Posts: 70 Location: Oneida,wi Joined: Jul 7^th, 2010	25-20 ss Sep 29^th, 2024 at 4:12pm	Print Post
	I have been using 25-20 winchester dies to neck size for my 25 -20 ss. How far down the neck do I need to size,all the way or just as far as the bullet gets seated? The neck in the chamber seems to be over size so I dont want to over work the brass.


	IP Logged

oneatatime Frequent Elocutionist Offline Posts: 3865 Location: Rocky Mountains Joined: Oct 30^th, 2011	Re: 25-20 ss Reply #1 - Sep 29^th, 2024 at 5:25pm	Print Post
	I size just as far as the bullet gets seated.


	IP Logged

wildthing Junior Member Offline Posts: 70 Location: Oneida,wi Joined: Jul 7^th, 2010	Re: 25-20 ss Reply #2 - Sep 29^th, 2024 at 8:30pm	Print Post
	Right now I'm using a .259 bollet and it is a loose fit thats why I'm asking about the neck sizeing.


	IP Logged

wildthing Junior Member Offline Posts: 70 Location: Oneida,wi Joined: Jul 7^th, 2010	Re: 25-20 ss Reply #3 - Sep 29^th, 2024 at 8:34pm	Print Post
	Sorry, Oneatatime I was thinking something else when I wrote that last post. thank you for your reply.


	IP Logged

argie1891 Senior Forum Member Offline Posts: 267 Location: selah, washington Joined: Jul 8^th, 2010	Re: 25-20 ss Reply #4 - Sep 30^th, 2024 at 12:10am	Print Post
	i have been breach seating in my rifle, but C&H has dies in stock. In the past i have messed around using dies that are for other calibers. Even though i am a cheap scape i much prefer using the correct tool for the job. Forget to mention even though i breach seat i bought dies because i plan on using some fixed ammo at some point down the road; Joe G in central washing state

	if you think you have it figured out then you just dont understand
	IP Logged

oneatatime Frequent Elocutionist Offline Posts: 3865 Location: Rocky Mountains Joined: Oct 30^th, 2011	Re: 25-20 ss Reply #5 - Sep 30^th, 2024 at 12:07pm	Print Post
	I use 25-20 WCF dies with a 223 shellholder for sizing the neck and seating the bullet. Have had no need for full length resizing.


	IP Logged

wildthing Junior Member Offline Posts: 70 Location: Oneida,wi Joined: Jul 7^th, 2010	Re: 25-20 ss Reply #6 - Oct 1^st, 2024 at 6:03am	Print Post
	Thanks for all the replies.


	IP Logged

Page Index Toggle

Pages: 1

‹ Previous Topic | Next Topic ›

« Board Index ‹ Board Top

Top

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid XHTML

Valid CSS

Powered by Perl

Source Forge

Page completed in 0.3497 seconds.