Welcome, Guest. Please
Login
or
Register
ASSRA Home
Board Index
Help
Search
Login
Register
ASSRA Forum
›
General
›
General Discussion
› 32/35 Stevens
(Moderator Group: Moderator)
‹
Previous Topic
|
Next Topic
›
Pages: 1
Send Topic
Print
32/35 Stevens (Read 280 times)
SBoomer
Oldtimer
Offline
Posts: 916
Location: Michigan's Frozen North (U.P.)
Joined: Jan 28
th
, 2010
32/35 Stevens
Jun 22
nd
, 2024 at 7:03pm
Print Post
I needed some 32/35 cases for breechseating, so made up some tooling yesterday and today. Donor cases were new FC 30/30. I made a form die to swage the base dim to .400” using the hydraulic press. Then made a 2nd form die for the final form in the reloading press. Base bulge was trimmed off in the lathe. They turned out very well. L toR are the bulged case out of die #1, finish formed case out of die #2, and finished fireformed case. I annealed and fire formed all (8). It was either this project or start on building an Ark!
IP Logged
Bnelson
Full Member
Offline
Posts: 163
Location: Lower Michigan
Joined: Jan 5
th
, 2009
Re: 32/35 Stevens
Reply #1 -
Jun 23
rd
, 2024 at 3:13pm
Print Post
When I needed some, I took a 32-40 sizing die and trimmed a little off the end until it had the right base diameter. It worked well.
Bruce
IP Logged
Pages: 1
Send Topic
Print
‹
Previous Topic
|
Next Topic
›
Forum Jump »
Board Index
» 10 most recent Posts
» 10 most recent Topics
General
Announcements
General Discussion ««
Single Shot Rifles
Reloading the Single Shot Rifle
Gunsmithing Single Shot Rifles
Collecting Single Shot Rifles
Hunting with Single Shot Rifles
Rifle Photos
ASSRA Match Scores
For Sale/Trade
Support and Feedback
ASSRA.COM Feedback and Suggestions
Forum Help
Membership Support
« Board Index
‹ Board
ASSRA Forum
» Powered by
YaBB 2.6.12
!
YaBB Forum Software
© 2000-2024. All Rights Reserved.
Page completed in 1.3184 seconds.