ASSRA Forum › General › Reloading the Single Shot Rifle › 8.15x46R Inline Bullet seater
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic 8.15x46R Inline Bullet seater (Read 574 times)
40-65tom
Full Member
***
Offline



Posts: 129
Location: San Antonio
Joined: Dec 20th, 2005
8.15x46R Inline Bullet seater
Aug 6th, 2023 at 10:19am
Print Post  
Had this for years, never used it and mostly fishing around to see if anyone else has seen or has one. All brass and marked 8mm 46 1/2 on top. Thanks Tom
  
Back to top
 
IP Logged
 
rkba2nd
Frequent Elocutionist
*****
Offline



Posts: 1836
Location: earth
Joined: Feb 16th, 2009
Re: 8.15x46R Inline Bullet seater
Reply #1 - Aug 6th, 2023 at 12:14pm
Print Post  
Beautifully done seater.
  
rkba2nd
Back to top
 
IP Logged
 
yamoon
Oldtimer
*****
Offline


NRA Life, ASSRA , GGCA,
MCA

Posts: 815
Location: Junction City Kansas
Joined: Feb 11th, 2012
Re: 8.15x46R Inline Bullet seater
Reply #2 - Aug 6th, 2023 at 12:37pm
Print Post  
I read somewhere the original 8.15x46 was 46 1/2 later shortened to 46.
Mike
  
Back to top
 
IP Logged
 
40-65tom
Full Member
***
Offline



Posts: 129
Location: San Antonio
Joined: Dec 20th, 2005
Re: 8.15x46R Inline Bullet seater
Reply #3 - Aug 6th, 2023 at 1:56pm
Print Post  
Here is the rest of the "kit" that was with the seater. A Berdan de-prime tool that fits the 8.15 case. A powder measure that the funnel is a perfect fit on the case. Also not pictured were 30 G. Egestorff Linden Berdan cases, and a 100 primers.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.8309 seconds.