ASSRA Forum › General › Reloading the Single Shot Rifle › Mold question
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Mold question (Read 230 times)
Frank
Participating Member
*
Offline



Posts: 10
Location: Grand Prairie, Texas
Joined: Aug 5th, 2012
Mold question
Jun 16th, 2023 at 1:30pm
Print Post  
A friend gave me a Two Bullet MEI (Meister Bullet) aluminum mold – casts ~406gr w/30:1 alloy with the proper diameter .410” for my 40-65

Is this a special mold.  Makes good bullets that shoot well.   

I am a novice and suspect that not all molds are created equally. 
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0908 seconds.