ASSRA Forum › General › Reloading the Single Shot Rifle › Lyman 3117 Bullet Mould
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Lyman 3117 Bullet Mould (Read 1472 times)
JerryH
Frequent Elocutionist
*****
Offline


ASSRA Member #10876

Posts: 1240
Location: Easton, CA
Joined: Nov 9th, 2014
Re: Lyman 3117 Bullet Mould
Reply #15 - Mar 16th, 2023 at 9:28pm
Print Post  
I doubt there is an off-the-shelf mould available for what I need. .316/.310 groove/bore diameter for a 16 twist barrel. I was just wondering what the Lyman 3117 looks like. I have a custom mould ordered from a friend. 

Thanks to everyone for your help.
  
I'm not a complete idiot, some of my parts are missing.
Back to top
 
IP Logged
 
Sure shot
Oldtimer
*****
Offline



Posts: 901
Location: East central Iowa
Joined: Jun 22nd, 2020
Re: Lyman 3117 Bullet Mould
Reply #16 - Mar 16th, 2023 at 9:35pm
Print Post  
The 311264 bullet mold looks very similar to the 308241 that I have.
  
Back to top
 
IP Logged
 
semtav
Full Member
***
Offline



Posts: 100
Joined: Oct 2nd, 2009
Re: Lyman 3117 Bullet Mould
Reply #17 - Mar 16th, 2023 at 11:49pm
Print Post  
I saw that picture too, but that must have been the earliest version, because my ideal mould has a meplate and nose just like the 3117
  
Back to top
 
IP Logged
 
Cbashooter
Frequent Elocutionist
*****
Offline



Posts: 1569
Location: Eastern Wa.
Joined: Mar 31st, 2018
Re: Lyman 3117 Bullet Mould
Reply #18 - Mar 17th, 2023 at 2:39pm
Print Post  
JerryH wrote on Mar 16th, 2023 at 9:28pm:
I doubt there is an off-the-shelf mould available for what I need. .316/.310 groove/bore diameter for a 16 twist barrel. I was just wondering what the Lyman 3117 looks like. I have a custom mould ordered from a friend. 

Thanks to everyone for your help.


You know I have a goofy little custom re cut mold that might work for you I will send it your way.
PM me your address.
  
Back to top
 
IP Logged
 
JerryH
Frequent Elocutionist
*****
Offline


ASSRA Member #10876

Posts: 1240
Location: Easton, CA
Joined: Nov 9th, 2014
Re: Lyman 3117 Bullet Mould
Reply #19 - Mar 17th, 2023 at 3:56pm
Print Post  
Thank you George!
  
I'm not a complete idiot, some of my parts are missing.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7044 seconds.