ASSRA Forum - Browning BPCR Vernier sight question

ASSRA Forum › General › General Discussion › Browning BPCR Vernier sight question

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Browning BPCR Vernier sight question (Read 532 times)

fayettefatts Participating Member Offline Posts: 19 Joined: Jan 18^th, 2022	Browning BPCR Vernier sight question Jan 4^th, 2023 at 10:37am	Print Post
	Can anyone tell me if the Browning BPCR vernier sight will fit a Winchester Traditional Hunter? I thought I read that it will fit, but I can't remember where I read it.


	IP Logged

Ranch13 Oldtimer Offline Posts: 548 Location: East Central Wy. Joined: Jan 20^th, 2018	Re: Browning BPCR Vernier sight question Reply #1 - Jan 4^th, 2023 at 12:27pm	Print Post
	It should fit fine. The hole spacing and angle of the tang should be the same as the bpcr action


	IP Logged

rgchristensen Frequent Elocutionist Offline Posts: 1091 Joined: Jan 2^nd, 2014	Re: Browning BPCR Vernier sight question Reply #2 - Jan 4^th, 2023 at 2:53pm	Print Post
	Some of the Browning single-shots don't have a rear upper tang, such as the one that the BPCR has to mount the sight. I have in the past fitted such a sight by inletting a brass threaded insert into the top of the wrist of the stock. CHRIS


	IP Logged

Cbashooter Frequent Elocutionist Offline Posts: 1572 Location: Eastern Wa. Joined: Mar 31^st, 2018	Re: Browning BPCR Vernier sight question Reply #3 - Jan 8^th, 2023 at 11:55am	Print Post
	fayettefatts wrote on Jan 4^th, 2023 at 10:37am: Can anyone tell me if the Browning BPCR vernier sight will fit a Winchester Traditional Hunter? I thought I read that it will fit, but I can't remember where I read it. yes it fits.i have them on other Mirouku 1885 rifles with tangs.


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 0.8794 seconds.