ASSRA Forum - Requesting unmarked ladder sight I.D.

ASSRA Forum › General › General Discussion › Requesting unmarked ladder sight I.D.

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Requesting unmarked ladder sight I.D. (Read 762 times)

Pentz Senior Forum Member Offline Funf und Zwanzig mit den Hut Posts: 417 Location: Vancouver, WA Joined: Sep 4^th, 2014	Requesting unmarked ladder sight I.D. Nov 3^rd, 2022 at 6:41pm	Print Post
	I obtained this sight with a hadley cup from a local estate. No markings whatsoever. Trying to figure out the manufacturer. I'd appreciate assistance. Thanks, Mike

	ASSRA Member Yoostabe # 11497
	IP Logged

Deadeye Bly Frequent Elocutionist Offline Posts: 1059 Location: Stephens City Joined: Feb 25^th, 2011	Re: Requesting unmarked ladder sight I.D. Reply #1 - Nov 3^rd, 2022 at 8:34pm	Print Post
	Pretty sure it is from Parts Unknown aka Red River. Made in Ukraine and imported by Sergio Pustowhatever


	IP Logged

Ranch13 Oldtimer Offline Posts: 555 Location: East Central Wy. Joined: Jan 20^th, 2018	Re: Requesting unmarked ladder sight I.D. Reply #2 - Nov 3^rd, 2022 at 10:40pm	Print Post
	Pretty sure Mr. Bly is right. If you don't have the flat spring for it you may be hosed to get it to work properly.


	IP Logged

rodneys Oldtimer Online Posts: 686 Location: Central Oklahoma Joined: Mar 2^nd, 2015	Re: Requesting unmarked ladder sight I.D. Reply #3 - Nov 4^th, 2022 at 8:23am	Print Post
	Yes it is one of the Ukrainian made sights. If you need a spring I may have an extra.


	IP Logged

bluesman Full Member Offline Posts: 192 Location: Paradise, California Joined: May 29^th, 2006	Re: Requesting unmarked ladder sight I.D. Reply #4 - Nov 5^th, 2022 at 6:21pm	Print Post
	I had the exact same Parts Unknown sight in my stuff in the shop that burned down back in 2018.Found the sight in the ashes and tossed it in a bucket of ATF fluid, most of it was too far gone but I did keep the base and that spring, you'd have to re-temper the spring but that's not hard.It's yours if you want it. Paul


	WWW IP Logged

Pentz Senior Forum Member Offline Funf und Zwanzig mit den Hut Posts: 417 Location: Vancouver, WA Joined: Sep 4^th, 2014	Re: Requesting unmarked ladder sight I.D. Reply #5 - Nov 7^th, 2022 at 4:58pm	Print Post
	Thanks Paul. another member is sending one. Oroville boy here, went to school at Pentz. Mike bluesman wrote on Nov 5^th, 2022 at 6:21pm: I had the exact same Parts Unknown sight in my stuff in the shop that burned down back in 2018.Found the sight in the ashes and tossed it in a bucket of ATF fluid, most of it was too far gone but I did keep the base and that spring, you'd have to re-temper the spring but that's not hard.It's yours if you want it. Paul

	ASSRA Member Yoostabe # 11497
	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 1.0303 seconds.