ASSRA Forum › General › Reloading the Single Shot Rifle › advice in making a mould for a pickett rifle
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic advice in making a mould for a pickett rifle (Read 568 times)
ralphscutlass
Newbie
*
Offline



Posts: 2
Joined: Mar 17th, 2019
advice in making a mould for a pickett rifle
Jul 21st, 2022 at 3:31pm
Print Post  
Hello
I have a Philips picket rifle from about 1860. the twist rate is 1 in 40. the bore diameter is .500 and the groove diameter is .486.
Using the greenhill formula I came up with a length of  the bullet which is .938.
question I have is what diameter should I make the Mould? Should it be .486 and use a cloth patch or should I deduct the thickness of the cloth patch from the diameter of .486?
Any help would be appreciated.
  
Back to top
 
IP Logged
 
MrTipUp
Frequent Elocutionist
*****
Offline


Quality is to a product
what character is to
a man

Posts: 1308
Location: Indiana
Joined: Feb 19th, 2020
Re: advice in making a mould for a pickett rifle
Reply #1 - Jul 21st, 2022 at 4:18pm
Print Post  
Barrels bored for conical picket-style bullets may not shoot well with greased or paper-patched bullets of a more conventional style  If you could produce a dimensioned drawing, I imagine that Accuate wold be willing to make you a mould.

Bill Lawrence
  
Back to top
 
IP Logged
 
KFW
Oldtimer
*****
Offline



Posts: 555
Location: Powell Wy.
Joined: Dec 18th, 2016
Re: advice in making a mould for a pickett rifle
Reply #2 - Jul 21st, 2022 at 5:25pm
Print Post  
Does your rifle have a false muzzle, or is the muzzle turned round for a starter?
  
Back to top
 
IP Logged
 
ralphscutlass
Newbie
*
Offline



Posts: 2
Joined: Mar 17th, 2019
Re: advice in making a mould for a pickett rifle
Reply #3 - Jul 21st, 2022 at 5:46pm
Print Post  
it has a false muzzle which I have
  
Back to top
 
IP Logged
 
Saratoga Bill
Participating Member
*
Offline



Posts: 40
Location: Saratoga NY or Crystal River F
Joined: Oct 18th, 2016
Re: advice in making a mould for a pickett rifle
Reply #4 - Jul 24th, 2022 at 5:23pm
Print Post  
Following this. Mine is a recently acquired SW Evans of 40 cal. Mine is turned with no false muzzle so I expect to start at lands minus patch.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.9691 seconds.