ASSRA Forum › General › Collecting Single Shot Rifles › Low Wall Barrel Markings
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Low Wall Barrel Markings (Read 1025 times)
Aussie_Hunter
Full Member
***
Offline



Posts: 193
Location: Hervey Bay,Queensland
Joined: Jul 7th, 2008
Low Wall Barrel Markings
May 19th, 2022 at 2:24am
Print Post  
Picked up a  44 WCF Low Wall the other day, its manufacturers details and calibre markings are both on the top  of the (hex) barrel,  whereas all the  others I have  the markings are on  the left hand side of the bbl.This  ones  serial no.is 78,049, whereas all  the  others have serial nos. above 100,000. Is this normal? thank you,  d.
  
Back to top
 
IP Logged
 
Aussie_Hunter
Full Member
***
Offline



Posts: 193
Location: Hervey Bay,Queensland
Joined: Jul 7th, 2008
Re: Low Wall Barrel Markings
Reply #1 - May 25th, 2022 at 12:18am
Print Post  
May have answered my own question,just got  another low wall with a serial no.under 100,000, and it also has details on top  of bbl.
  
Back to top
 
IP Logged
 
George Babits
Frequent Elocutionist
*****
Offline



Posts: 1106
Joined: Sep 27th, 2012
Re: Low Wall Barrel Markings
Reply #2 - May 25th, 2022 at 6:35pm
Print Post  
Your "hex" barrel is extremely rare!!!   Nearly every rifle I have ever seen has had an octagonal barrel.  That's 8 flats.   Your "hex" barrel  with only 6 sides has got to be maybe one of a kind.

George
  
Back to top
 
IP Logged
 
Aussie_Hunter
Full Member
***
Offline



Posts: 193
Location: Hervey Bay,Queensland
Joined: Jul 7th, 2008
Re: Low Wall Barrel Markings
Reply #3 - May 26th, 2022 at 8:07pm
Print Post  
George, blame my "chemo brain", I should have  said octagonal NOT hex, apologies, d.
  
Back to top
 
IP Logged
 
bpcrnut
Participating Member
*
Offline



Posts: 41
Location: SE Mn
Joined: Nov 2nd, 2018
Re: Low Wall Barrel Markings
Reply #4 - May 29th, 2022 at 8:55am
Print Post  
Most Winchester 1885 Mfg and caliber details are on the top of the barrel.  In later years it’s not uncommon to see that info at the 45 degree flat left of the top flat.   I suspect this was done so that the Winchester roll stamp and caliber marking didn’t get mangled if a scope were installed.
  
Back to top
AIM  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7912 seconds.