ASSRA Forum › General › Reloading the Single Shot Rifle › Need low pressure .32 Win Special load- BSA Cadet?
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Need low pressure .32 Win Special load- BSA Cadet? (Read 3757 times)
Hiwall55
Senior Forum Member
****
Offline



Posts: 468
Location: west central Illinois
Joined: Jun 30th, 2012
Re: Need low pressure .32 Win Special load- BSA Cadet?
Reply #15 - Aug 9th, 2021 at 7:45pm
Print Post  
If memory serves me right the lyman #3 has about 8 powders listed, tell me which powders you have and will post them.
  
Back to top
 
IP Logged
 
MartiniBelgian
Frequent Elocutionist
*****
Offline



Posts: 1712
Location: Aarschot
Joined: Jun 7th, 2004
Re: Need low pressure .32 Win Special load- BSA Cadet?
Reply #16 - Aug 10th, 2021 at 5:06am
Print Post  
Schuetzendave wrote on Aug 9th, 2021 at 2:44pm:
Mainly the pin holding the swinging block in the trigger guard plus the pin holding the trigger block into the receiver can have the pins  pound out the holes they reside in from excessive recoil pressure.
Remember this lightweight rotating block is not encased in a solid metal channel on four sides like a High Wall.

Actually, those pins aren' stressed when shooting, they aren't supposed to take any recoil.  The rifle would even fire safely without that pin. That's called good design.
  
Back to top
WWW  
IP Logged
 
oneatatime
Frequent Elocutionist
*****
Offline



Posts: 4036
Location: Rocky Mountains
Joined: Oct 30th, 2011
Re: Need low pressure .32 Win Special load- BSA Cadet?
Reply #17 - Aug 10th, 2021 at 12:17pm
Print Post  
That's what I was thinking, Gert. It would certainly be true for the large actions. Maybe the Cadet has enough clearance between the insert and the frame that greater back thrust could lead to case stretching.
  
Back to top
 
IP Logged
 
MartiniBelgian
Frequent Elocutionist
*****
Offline



Posts: 1712
Location: Aarschot
Joined: Jun 7th, 2004
Re: Need low pressure .32 Win Special load- BSA Cadet?
Reply #18 - Aug 10th, 2021 at 1:45pm
Print Post  
That would be the case with the Nepalese ones, not with the Brit versions.  They lock like a bank vault tolerance wise.
  
Back to top
WWW  
IP Logged
 
RJ-35-40
Full Member
***
Offline



Posts: 163
Joined: Dec 7th, 2016
Re: Need low pressure .32 Win Special load- BSA Cadet?
Reply #19 - Aug 19th, 2021 at 3:13pm
Print Post  
Deleted, found the info
« Last Edit: Aug 19th, 2021 at 3:20pm by RJ-35-40 »  
Back to top
 
IP Logged
 
Barrabruce
Junior Member
**
Offline



Posts: 77
Location: Australia
Joined: Mar 30th, 2017
Re: Need low pressure .32 Win Special load- BSA Cadet?
Reply #20 - Aug 20th, 2021 at 8:24pm
Print Post  
I have a 30-30 and shooting the Lee soup can 115 grns.
3 grains bullseye with a 1/2" sq toilet paper on powder works o.k.

In my  310 cadet with 120 gns I use 2 grains bullseye for a quiet load 3 grains is plenty enough I think.

If you want some milder plinking/small game  loads.




  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.6081 seconds.