ASSRA Forum › General › Reloading the Single Shot Rifle › Making a .41 rimfire short case from bar stock
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 2 [3]  Send TopicPrint
Very Hot Topic (More than 25 Replies) Making a .41 rimfire short case from bar stock (Read 5375 times)
ndnchf
Frequent Elocutionist
*****
Offline



Posts: 1079
Joined: Mar 6th, 2014
Re: Making a .41 rimfire short case from bar stock
Reply #30 - Aug 8th, 2021 at 10:42am
Print Post  
I reprimed the Navy Arms .41 rimfire case. Then using a drop tube I was able to load 12.0gr of Old E. 3F into it with a little room to spare. With just a little compression I was able to create enough space for the bullet's heel. On the left is the machined case with a very compressed 11.0gr of Old E. On the right is the Navy Arms case with 12.0gr.

  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 2 [3] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2442 seconds.