ASSRA Forum › General › General Discussion › Need help to identify this mold.
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Need help to identify this mold. (Read 581 times)
rraffl
Participating Member
*
Offline



Posts: 31
Location: Walhalla, South Carolina
Joined: Feb 5th, 2014
Need help to identify this mold.
Jun 6th, 2021 at 1:24pm
Print Post  
Hi all. I'd like to sell this mold but have forgotten what weight bullet it will cast. I think it is a 32-40 .321 Hoch mold either 180 or 200 grain. Can anyone identify the mold type? The cavity is about 1.078 in length and it is a nose pour mold. Thanks for your help.
  
Back to top
 
IP Logged
 
JLouis
Frequent Elocutionist
*****
Offline



Posts: 10625
Joined: Apr 8th, 2009
Re: Need help to identify this mold.
Reply #1 - Jun 6th, 2021 at 1:48pm
Print Post  
Appears to be a Hoch mould on RCBS handles. The mould should marked on its side and pointing out its casting size.
  
" It Is Better To Now Have Been A Has Been Than A Never Was Or A Wanna Be "
Back to top
 
IP Logged
 
rraffl
Participating Member
*
Offline



Posts: 31
Location: Walhalla, South Carolina
Joined: Feb 5th, 2014
Re: Need help to identify this mold.
Reply #2 - Jun 6th, 2021 at 6:26pm
Print Post  
"Appears to be a Hoch mould on RCBS handles. The mould should marked on its side and pointing out its casting size."

Thanks. I'm and idiot, didn't see it.  322 200D 

  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7688 seconds.