ASSRA Forum - Could use some help identifying a front sight.

ASSRA Forum › General › Single Shot Rifles › Could use some help identifying a front sight.

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Could use some help identifying a front sight. (Read 1220 times)

Heidinnprudr Participating Member Offline Posts: 15 Joined: Sep 18^th, 2020	Could use some help identifying a front sight. Apr 29^th, 2021 at 9:34am	Print Post
	Would like obtain some other inserts. Thank you


	IP Logged

Smoke Oldtimer Offline Posts: 693 Location: San Diego Joined: Feb 24^th, 2013	Re: Could use some help identifying a front sight. Reply #1 - Apr 30^th, 2021 at 1:41am	Print Post
	What's the width of the insert below the cut (where it's smaller) and the height?


	IP Logged

ssrifles Senior Forum Member Offline Posts: 273 Joined: Mar 23^rd, 2009	Re: Could use some help identifying a front sight. Reply #2 - May 5^th, 2021 at 9:23am	Print Post
	they look just like the ones i made for the sharps. need thickness and height. tony <><


	IP Logged

Green_Frog Frequent Elocutionist Offline "It ain't easy being green" ASSRA Life #281 Posts: 4001 Location: Lynchburg, VA Joined: Apr 18^th, 2004	Re: Could use some help identifying a front sight. Reply #3 - Jun 4^th, 2021 at 11:43am	Print Post
	That insert doesn’t look like the ones I have seen in sights with that style retainer. The ones I am used to have a little “tail” on each side of the bottom, and when you want to change them you pull the slide that holds the spirit level back and lift out the insert... reassemble by reversing the process. The inserts like the one pictured are held in place either by a flat spring on top of the globe or by a screw in piece that holds it in by friction. What is holding your insert in place if you turn the rifle sideways? Froggie


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 0.6110 seconds.