ASSRA Forum › General › Single Shot Rifles › Help identifying rear tang sight staff
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Help identifying rear tang sight staff (Read 885 times)
Cbashooter
Frequent Elocutionist
*****
Offline



Posts: 1605
Location: Eastern Wa.
Joined: Mar 31st, 2018
Help identifying rear tang sight staff
Feb 1st, 2021 at 8:00pm
Print Post  
What it it?
Appears to have been shortened at the base
  
Back to top
 
IP Logged
 
rgchristensen
Frequent Elocutionist
*****
Offline



Posts: 1162
Joined: Jan 2nd, 2014
Re: Help identifying rear tang sight staff
Reply #1 - Feb 2nd, 2021 at 6:42am
Print Post  
Looks like a "home-made".   Any graduations?
CHRIS
  
Back to top
 
IP Logged
 
830singleshot
Senior Forum Member
****
Offline



Posts: 456
Location: Texas
Joined: Feb 11th, 2007
Re: Help identifying rear tang sight staff
Reply #2 - Feb 2nd, 2021 at 9:04am
Print Post  
I think the screw is a factory product.  The radius under the head and the knurling is first rate.
The eye cup is very crude by comparison as well as the welds at the bottom of the staff being unfinished.
  
J. Scott McCash&&New Braunfels, TX&&830-237-2376&&jsmccash@yahoo.com
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0724 seconds.