ASSRA Forum › General › Reloading the Single Shot Rifle › Forming 30 Schwartz Cases
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Forming 30 Schwartz Cases (Read 807 times)
bnice
Frequent Elocutionist
*****
Offline



Posts: 1851
Location: Iowa
Joined: Nov 30th, 2006
Forming 30 Schwartz Cases
Jul 24th, 2020 at 7:34am
Print Post  
Any suggestions on forming 30 Schwartz cases. It appears to be the longer version. If a chamber reamer is found can a good size die be made? Are dies available any where. I assume 30-30 parent case is easiest and cheapest route.
  
Back to top
 
IP Logged
 
irish66
Oldtimer
*****
Offline



Posts: 534
Location: newbraunfels
Joined: Apr 7th, 2007
Re: Forming 30 Schwartz Cases
Reply #1 - Jul 24th, 2020 at 7:56am
Print Post  
Had one a while back on a mod j reciever.
I used 30-30 brass, and dies from ch4d
Did them in stages, worked fine.
Case length not that important if breech seating.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5018 seconds.