ASSRA Forum › General › Reloading the Single Shot Rifle › range loading snafu
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) range loading snafu (Read 4097 times)
Cbashooter
Frequent Elocutionist
*****
Offline



Posts: 1570
Location: Eastern Wa.
Joined: Mar 31st, 2018
Re: range loading snafu
Reply #15 - Jul 15th, 2020 at 8:36pm
Print Post  
primer in the funnel got me again today! 
I had 4 shots in .3  at 100 and then a  semi blooper dropped out 1.5".I shot a 6th with full charge and it went right in the gob of shots!
some people never learn!
  
Back to top
 
IP Logged
 
calledflyer
Frequent Elocutionist
*****
Offline



Posts: 3561
Joined: Mar 9th, 2015
Re: range loading snafu
Reply #16 - Jul 15th, 2020 at 9:02pm
Print Post  
If you are using a funnel that small, you could open the mouth up and a primer will fall through. Still fit into a .32-40 case mouth. How does it get in there to begin? I'm not able to figure this.
  
Back to top
 
IP Logged
 
Cbashooter
Frequent Elocutionist
*****
Offline



Posts: 1570
Location: Eastern Wa.
Joined: Mar 31st, 2018
Re: range loading snafu
Reply #17 - Jul 15th, 2020 at 9:38pm
Print Post  
calledflyer wrote on Jul 15th, 2020 at 9:02pm:
If you are using a funnel that small, you could open the mouth up and a primer will fall through. Still fit into a .32-40 case mouth. How does it get in there to begin? I'm not able to figure this.



The funnel is screwed right next to the side of my belding and mull  measure. when I meter  the charge in the tube  I put the case under it and throw it directly in. Even though I de Prime below bench level I think a primer once in awhile gets a little "energetic" and ends up in the funnel.
« Last Edit: Jul 15th, 2020 at 9:43pm by Cbashooter »  
Back to top
 
IP Logged
 
westerner
Frequent Elocutionist
*****
Offline


deleted posts and threads
record holder.

Posts: 11458
Location: Why, out West of course
Joined: May 29th, 2006
Re: range loading snafu
Reply #18 - Jul 15th, 2020 at 11:21pm
Print Post  
Cbashooter wrote on Jul 15th, 2020 at 9:38pm:
calledflyer wrote on Jul 15th, 2020 at 9:02pm:
If you are using a funnel that small, you could open the mouth up and a primer will fall through. Still fit into a .32-40 case mouth. How does it get in there to begin? I'm not able to figure this.



The funnel is screwed right next to the side of my belding and mull  measure. when I meter  the charge in the tube  I put the case under it and throw it directly in. Even though I de Prime below bench level I think a primer once in awhile gets a little "energetic" and ends up in the funnel.

  
A blind squirrel runs into a tree every once in a while.
Back to top
 
IP Logged
 
calledflyer
Frequent Elocutionist
*****
Offline



Posts: 3561
Joined: Mar 9th, 2015
Re: range loading snafu
Reply #19 - Jul 15th, 2020 at 11:50pm
Print Post  
Well, just make the hole bigger than a primer and they'll go on through. Must be on helluva decapper to toss 'em up there. Good luck.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.3662 seconds.