ASSRA Forum › General › Reloading the Single Shot Rifle › Rimless case and shoulder set back
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Rimless case and shoulder set back (Read 5568 times)
joeb33050
Frequent Elocutionist
*****
Offline



Posts: 2613
Location: Marathon, FL
Joined: Apr 20th, 2004
Re: Rimless case and shoulder set back
Reply #15 - Jun 15th, 2020 at 6:12am
Print Post  
joeb33050 wrote on Jun 14th, 2020 at 6:32am:
Oil, lube, grease the case, very little, and solve the problem.



Works every time.
  
Back to top
 
IP Logged
 
boats
Frequent Elocutionist
*****
Offline



Posts: 7544
Location: Virginia
Joined: Apr 23rd, 2004
Re: Rimless case and shoulder set back
Reply #16 - Jun 22nd, 2020 at 10:37am
Print Post  
Well documented issue.  All the above advise is sound.  I keep low pressure rimless load cases separated . You can save them but something like 30/06 Or 308 I just toss the case.  I did have one 03 used exclusively with cast and ran a light spring & pistol primers. Worked well 

Boats
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7799 seconds.