Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Unknown bullet mold (Read 1418 times)
Tom_Trevor assra life no.71
Oldtimer
*****
Offline


Tom Trevor

Posts: 695
Location: Granada Hills Ca.
Joined: Jun 16th, 2004
Unknown bullet mold
Sep 4th, 2018 at 12:29pm
Print Post  
I have this mold that casts two different bullets both .257 diameter from an old local collection. It does not have a single mark on it. Do not think its a Hensley and Gibbs as they all seem to be marked. The location of the pin retainer screws could be the give away.
  
Back to top
 
IP Logged
 
Schutzenbob
Frequent Elocutionist
*****
Offline


Rheinisch-Westfälisc
hen Sprengstoff-Fabriken

Posts: 2057
Location: Nightingale, California
Joined: Oct 24th, 2005
Re: Unknown bullet mold
Reply #1 - Sep 4th, 2018 at 12:36pm
Print Post  
Tom, 

I'm not sure, but Cramer molds were constructed like that.  Huh
  
Back to top
 
IP Logged
 
old7groove
Junior Member
**
Offline



Posts: 81
Location: San Diego
Joined: Jul 6th, 2016
Re: Unknown bullet mold
Reply #2 - Sep 4th, 2018 at 1:15pm
Print Post  
Tom, 
Having worked with SAECO RELOADING who purchased Cramer Bullet Molds, and had many examples of Cramer products in their archives the mold shown does appear to be of Cramer 
manufacture.
BW Darr


  
Back to top
 
IP Logged
 
Tom_Trevor assra life no.71
Oldtimer
*****
Offline


Tom Trevor

Posts: 695
Location: Granada Hills Ca.
Joined: Jun 16th, 2004
Re: Unknown bullet mold
Reply #3 - Sep 4th, 2018 at 4:10pm
Print Post  
Thanks Barry and Bob I just could not pull it up. Hope you and yours are well.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint