ASSRA Forum › General › Reloading the Single Shot Rifle › Got a new mold from Accurate
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Got a new mold from Accurate (Read 5242 times)
oneatatime
Frequent Elocutionist
*****
Offline



Posts: 4465
Location: Rocky Mountains
Joined: Oct 30th, 2011
Re: Got a new mold from Accurate
Reply #15 - Jun 18th, 2018 at 1:32pm
Print Post  
Greg, when the bottom of the bucket is covered with bullets I add 2 more layers of felt and keep casting. Usually that coincides with my sprue box being full so I add them to the pot, put the molds back on the hot plate and take a stretch while the lead is coming back to temp.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1029 seconds.