ASSRA Forum › General › Single Shot Rifles › small primer brass
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) small primer brass (Read 6864 times)
JLouis
Frequent Elocutionist
*****
Offline



Posts: 10625
Joined: Apr 8th, 2009
Re: small primer brass
Reply #15 - Mar 4th, 2018 at 7:50pm
Print Post  
I'll be damned Jeff just when he who knows the most say's good luck finding it they quit making it long ago as if it is now non existent. Shorty there after another one here speaks up here almost instantly and says it's your lucky day and all from just simply asking.

JLouis
« Last Edit: Mar 4th, 2018 at 8:01pm by JLouis »  
" It Is Better To Now Have Been A Has Been Than A Never Was Or A Wanna Be "
Back to top
 
IP Logged
 
frnkeore
Frequent Elocutionist
*****
Online



Posts: 7247
Location: Central Point, OR 97502
Joined: Jun 16th, 2010
Re: small primer brass
Reply #16 - Mar 4th, 2018 at 8:42pm
Print Post  
To bad you can't just ask for a brain or common sense and get it Wink

Frank
  
ASSRA Member #696, ISSA Member #339
Back to top
YIMAIM  
IP Logged
 
John Boy
Ex Member


Re: small primer brass
Reply #17 - Mar 4th, 2018 at 9:26pm
Print Post  
How to make sleeves for Large Pockets to Small Pockets ... (You need to Login or Register to view media files and links)
« Last Edit: Mar 4th, 2018 at 9:37pm by »  
Back to top
 
IP Logged
 
uscra112
Frequent Elocutionist
*****
Offline



Posts: 4079
Location: Switzerland of Ohio
Joined: May 7th, 2007
Re: small primer brass
Reply #18 - Mar 24th, 2018 at 3:17pm
Print Post  
What ever happened to the old dodge of putting a disk of newsprint in the case prior to loading in  the powder charge?

Are large boxer primers the same diameter as the Berdans used to prime 7.5x55 Swiss?   There have been threads on military-rifle forae showing how to take the top off those OEM Swiss primers, leaving the sides in place.  After drilling out the Berdan anvil, you swage the remainder of the primer against the sides of the hole, and lo-and-behold, a small Boxer primer is a good fit!  Did a few myself, but decided it was a LOT less trouble to ante up for some new Norma brass.   

(Might be all wet.  I'm too much under the weather today to  go dig out my 7.5 stuff to measure.)

  
<div class=
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4026 seconds.