ASSRA Forum › General › Collecting Single Shot Rifles › Remington Rolling Block Rigby treatment
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Remington Rolling Block Rigby treatment (Read 1502 times)
prewar
Newbie
*
Offline



Posts: 1
Joined: Dec 5th, 2012
Remington Rolling Block Rigby treatment
Dec 6th, 2017 at 6:50pm
Print Post  
I'm hoping someone has an original RB that has Rigby barrel flats and that they can get me the length and width of the flats. This is for a project that is ready for the barrel profiling and a verification would be good.  I have scaled measurements from photos and it appears that 2 3/4" x .500" is about right.

Thanks,
Dennis
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.9995 seconds.