ASSRA Forum - 32-40 bullet moulds

ASSRA Forum › General › Reloading the Single Shot Rifle › 32-40 bullet moulds

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Page Index Toggle

Pages: 1

Normal Topic

32-40 bullet moulds (Read 3318 times)

Ponderosa Paul Junior Member Offline Posts: 69 Joined: Nov 17^th, 2013	32-40 bullet moulds Sep 3^rd, 2017 at 11:46pm	Print Post
	I`m finishing a 32-40 target rifle with a BRC barrel. Now I am looking at bullet moulds,plain base only . Any recommendations, thank you, Paul.


	IP Logged

Schuetzenmiester Frequent Elocutionist Offline Posts: 6707 Location: Cool Wet Side of WA Joined: Apr 27^th, 2008	Re: 32-40 bullet moulds Reply #1 - Sep 3^rd, 2017 at 11:51pm	Print Post
	lots of options. Best to match one for your twist.

	"some old things are lovely, warm still with life ... of the forgotten men who made them." - D.H. Lawrence
	IP Logged

bnice Frequent Elocutionist Offline Posts: 1964 Location: Iowa Joined: Nov 30^th, 2006	Re: 32-40 bullet moulds Reply #2 - Sep 4^th, 2017 at 10:34am	Print Post
	Ken what primer do you use with the 300 mp?


	IP Logged

Schuetzenmiester Frequent Elocutionist Offline Posts: 6707 Location: Cool Wet Side of WA Joined: Apr 27^th, 2008	Re: 32-40 bullet moulds Reply #3 - Sep 4^th, 2017 at 1:17pm	Print Post
	westerner wrote on Sep 4^th, 2017 at 10:36am: Schuetzenmiester wrote on Sep 3^rd, 2017 at 11:51pm: lots of options. Best to match one for your twist. Lots of options. Best to match one for your groove diameter. Or even better do what Rafter3c says to do. Rafter has the most experience with BRC barrels. Joe. I wouldn't start with a round ball of the proper diameter

	"some old things are lovely, warm still with life ... of the forgotten men who made them." - D.H. Lawrence
	IP Logged

Schuetzenmiester Frequent Elocutionist Offline Posts: 6707 Location: Cool Wet Side of WA Joined: Apr 27^th, 2008	Re: 32-40 bullet moulds Reply #4 - Sep 4^th, 2017 at 1:52pm	Print Post
	Ken, That was just a sarcastic response to Joe's scarcasim

	"some old things are lovely, warm still with life ... of the forgotten men who made them." - D.H. Lawrence
	IP Logged

MT Chambers Full Member Offline Posts: 141 Location: Foam Lake, Saskatchewan Joined: Oct 3^rd, 2011	Re: 32-40 bullet moulds Reply #5 - Sep 4^th, 2017 at 2:32pm	Print Post
	Don't dismiss the 8mm molds out there, depending on size requirements.


	IP Logged

Page Index Toggle

Pages: 1

‹ Previous Topic | Next Topic ›

« Board Index ‹ Board Top

Top

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid XHTML

Valid CSS

Powered by Perl

Source Forge

Page completed in 0.7876 seconds.