ASSRA Forum › General › Reloading the Single Shot Rifle › Hoch acton information
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Hoch acton information (Read 2504 times)
lars
Newbie
*
Offline


Enjoy Tacoma Shoots

Posts: 4
Location: Washington State
Joined: Dec 15th, 2016
Hoch acton information
Dec 15th, 2016 at 3:53pm
Print Post  
I recently picked up a Hoch action and would like to know more about it.  Went to buy the Pouporri by Hass to look at the information and got a good shock as Track of the Wolf listed it at $22 but they are out.  Next was Amazon and sky high.  Does anyone have a chance to send just the Hoch information that de Hass ran on the Hoch.  This is probably one of the kit builds.
Lars
  
Back to top
 
IP Logged
 
4060may
Full Member
***
Offline



Posts: 196
Location: Richfield
Joined: Jul 12th, 2006
Re: Hoch acton information
Reply #1 - Dec 15th, 2016 at 5:07pm
Print Post  
pm with an email address, I have them in jpg format
  
Back to top
 
IP Logged
 
jfeldman
ASSRA Board Member
*****
Offline



Posts: 1120
Location: Imperial Beach, Ca
Joined: Nov 5th, 2005
Re: Hoch acton information
Reply #2 - Dec 16th, 2016 at 12:22am
Print Post  
Here's a couple pics from my early kit.

Regards, Joe
  
Back to top
 
IP Logged
 
lars
Newbie
*
Offline


Enjoy Tacoma Shoots

Posts: 4
Location: Washington State
Joined: Dec 15th, 2016
Re: Hoch acton information
Reply #3 - Dec 16th, 2016 at 4:09pm
Print Post  
Wow, thanks so much for such quick information.  This will help lots.  Rifle has a 32-20 blown out case to use true .32 bullet so it's .321 barrel.  Experimenting with it.  Using AA #9 as no 4759 anymore.
  
Back to top
 
IP Logged
 
beltfed
Frequent Elocutionist
*****
Offline



Posts: 1827
Location: Central Wi
Joined: Dec 20th, 2007
Re: Hoch acton information
Reply #4 - Dec 16th, 2016 at 5:21pm
Print Post  
One thing, my Hoch had some problem with failure to fire with some primers.   
I found a hardware store compression spring that is a slip fit inside the orig. striker spring and is even of the right length
and wire size/strength.
Now all primers fire
beltfed/arnie
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.4134 seconds.