ASSRA Forum › General › Single Shot Rifles › Stevens info needed
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Stevens info needed (Read 7292 times)
Schuetzenmiester
Frequent Elocutionist
*****
Offline



Posts: 6707
Location: Cool Wet Side of WA
Joined: Apr 27th, 2008
Re: Stevens info needed
Reply #15 - Feb 8th, 2016 at 1:56am
Print Post  
JerryH wrote on Feb 7th, 2016 at 11:22pm:
After looking closer I'll say that it's not a Falling Block Works Model S, but a close copy of one. That may explain no manufacture or serial number stamps.

JerryH


No serial number or mftr, must be one of a kind for personal use. ??
  
"some old things are lovely, warm still with life ... of the forgotten men who made them." - D.H. Lawrence
Back to top
 
IP Logged
 
mm1ut1
Junior Member
**
Offline



Posts: 75
Location: Sheboygan, wi
Joined: Jun 22nd, 2012
Re: Stevens info needed
Reply #16 - Feb 13th, 2016 at 1:36pm
Print Post  
More photos. Rifle is now at the Cabela's in 
Ritchfield, Wi. They let me take the forearm off and take a few photos. No markings on it except "45-70" stamped on the barrel. The barrel was relined. Firing pin is spring loaded. The hammer cocks when the lever is dropped.
  
I get by with a little help from my friends !
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0719 seconds.