ASSRA Forum › General › Reloading the Single Shot Rifle › bullet casting furnace
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) bullet casting furnace (Read 8793 times)
Marlene
Senior Forum Member
****
Offline



Posts: 276
Joined: Oct 30th, 2015
Re: bullet casting furnace
Reply #15 - Jan 25th, 2016 at 8:32pm
Print Post  
Where are folks getting their PID units? any particular make/model?
  
Back to top
 
IP Logged
 
Schuetzenmiester
Frequent Elocutionist
*****
Offline



Posts: 6707
Location: Cool Wet Side of WA
Joined: Apr 27th, 2008
Re: bullet casting furnace
Reply #16 - Jan 26th, 2016 at 7:18pm
Print Post  
I doubt it would improve my weight tolerance but could probably fine tune casting temp to increase production with lower mold cooling time.
  
"some old things are lovely, warm still with life ... of the forgotten men who made them." - D.H. Lawrence
Back to top
 
IP Logged
 
Etienne Brule
Newbie
*
Offline



Posts: 1
Location: Quebec Canada
Joined: Jul 12th, 2015
Re: bullet casting furnace
Reply #17 - Jan 26th, 2016 at 7:30pm
Print Post  
For a pot of 45 pounds ...
  
Back to top
 
IP Logged
 
Schuetzenmiester
Frequent Elocutionist
*****
Offline



Posts: 6707
Location: Cool Wet Side of WA
Joined: Apr 27th, 2008
Re: bullet casting furnace
Reply #18 - Jan 26th, 2016 at 7:50pm
Print Post  
That's about 30 pounds more bullets than I'm willing to cast in a session  Grin
  
"some old things are lovely, warm still with life ... of the forgotten men who made them." - D.H. Lawrence
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5603 seconds.