ASSRA Forum › General › Single Shot Rifles › Anybody use a Jard trigger on a #3 Ruger
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Anybody use a Jard trigger on a #3 Ruger (Read 1372 times)
Bulseyetom
Oldtimer
*****
Offline



Posts: 951
Location: Santa Maria, Ca
Joined: Oct 31st, 2010
Anybody use a Jard trigger on a #3 Ruger
Dec 21st, 2015 at 8:04pm
Print Post  
What are anybody's thoughts on installing a Jard trigger on a #3?  The current trigger (factory 2 screw model) is not bad at 4 pounds but has some creep that does not want to adjust out.  Thanks, and Merry Xmas to all.  Tom
  
Back to top
Twitter  
IP Logged
 
JS47
Frequent Elocutionist
*****
Offline



Posts: 1265
Location: Arizona
Joined: Oct 12th, 2012
Re: Anybody use a Jard trigger on a #3 Ruger
Reply #1 - Dec 21st, 2015 at 11:52pm
Print Post  
Don't know about the Jard but I use a Kepplinger (spelling?) on my #3.  It took out the creep to the point that I seldom use it set.  I just measured the pull weight and it is a pretty clean 26 oz. unset, 8 oz set.  I don't remember but I think I may have put a thin shim in the hammer notch to decrease the sear engagement. It's been awhile since I worked on it.  It's tough when your mind starts to go.

JS
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4454 seconds.