ASSRA Forum › General › General Discussion › IDEAL 1892 bullet luber
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic IDEAL 1892 bullet luber (Read 1572 times)
guns4065
Junior Member
**
Offline



Posts: 50
Location: bethlehem pa
Joined: Feb 21st, 2011
IDEAL 1892 bullet luber
Mar 8th, 2015 at 11:33am
Print Post  
Went to a gun show and picked up an ideal bullet luber.  I am missing 2 parts to it...1 is the shaft that goes on the bottom and the other is the middle piece with the   threads.  I would like to buy them...or can a machinist make these pieces?
  
Back to top
 
IP Logged
 
nuclearcricket
Oldtimer
*****
Offline



Posts: 823
Joined: Oct 15th, 2008
Re: IDEAL 1892 bullet luber
Reply #1 - Mar 9th, 2015 at 7:27am
Print Post  
They shouldn't be all that hard for a machinist to make. The only hard part would be to figure the thread diameter and pitch. Its hard to get the thread pitch from the inside of a hole that small. There may be a chance that the depth adjustment part that you need is the same as the one on the #45, if thats the case it would be very easy to have the parts made.
Sam
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2931 seconds.