ASSRA Forum › General › Reloading the Single Shot Rifle › Ideal mold info need
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Ideal mold info need (Read 1948 times)
ron
Oldtimer
*****
Offline



Posts: 576
Location: Augusta Maine
Joined: Nov 15th, 2009
Ideal mold info need
Feb 6th, 2015 at 6:52pm
Print Post  
I was given an ideal mold #358156, it also has a number at the bottom edge below the mold number. Would anyone be able to tell me the cal. and weight for this mold .

ron
  
Back to top
 
IP Logged
 
ron
Oldtimer
*****
Offline



Posts: 576
Location: Augusta Maine
Joined: Nov 15th, 2009
Re: Ideal mold info need
Reply #1 - Feb 6th, 2015 at 6:54pm
Print Post  
The number at the bottom edge is 136

ron
  
Back to top
 
IP Logged
 
frnkeore
Frequent Elocutionist
*****
Offline



Posts: 7611
Location: Central Point, OR 97502
Joined: Jun 16th, 2010
Re: Ideal mold info need
Reply #2 - Feb 6th, 2015 at 8:31pm
Print Post  
It's a bullet made for the 357 Mag. It should cast .360 and weigth 155 gr in Lyman #2 alloy.

If you check both sides of the mold may have that 136 number. If so, it's just a number to keep the mold halfs together.

Frank
  
ASSRA Member #696, ISSA Member #339
Back to top
YIMAIM  
IP Logged
 
ron
Oldtimer
*****
Offline



Posts: 576
Location: Augusta Maine
Joined: Nov 15th, 2009
Re: Ideal mold info need
Reply #3 - Feb 6th, 2015 at 8:43pm
Print Post  
Thanks Frank
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.4244 seconds.