ASSRA Forum › General › General Discussion › scopeblock calculation
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic scopeblock calculation (Read 1568 times)
Hank45
Oldtimer
*****
Offline


Beer is living proof that
GOD loves you

Posts: 506
Location: MA
Joined: Jan 21st, 2010
scopeblock calculation
Jan 31st, 2015 at 4:02am
Print Post  
How do you calculate the height of the front block to the height of the rear block? Thanks for your answer, Hank45
  
Back to top
 
IP Logged
 
Cat_Whisperer
Frequent Elocutionist
*****
Online


No 1, 9.3x74R

Posts: 3996
Location: Mountains of Virginia
Joined: Apr 17th, 2004
Re: scopeblock calculation
Reply #1 - Jan 31st, 2015 at 8:32am
Print Post  
IF you want them to be parallel to the bore; measure the two diameters, divide each diamter by two - that gives you the height above the axis of the bore at each place measured.  Subtract the smaller (front) from the larger and that gives you the amount the front one needs to be raised.
  
Cat Whisperer (trk)
Chief of Smoke
Pulaski Coehorn Works and Skunk Works
Drafted May 1970, Retired Maj. U.S.Army
assra #9885
Back to top
WWW  
IP Logged
 
Hank45
Oldtimer
*****
Offline


Beer is living proof that
GOD loves you

Posts: 506
Location: MA
Joined: Jan 21st, 2010
Re: scopeblock calculation
Reply #2 - Jan 31st, 2015 at 10:00am
Print Post  
Cat_Whisperer, when you write measure the two diameters do you mean the barrel diameters where the scope blocks are being placed? Thanks for your answer, Hank45
  
Back to top
 
IP Logged
 
Cat_Whisperer
Frequent Elocutionist
*****
Online


No 1, 9.3x74R

Posts: 3996
Location: Mountains of Virginia
Joined: Apr 17th, 2004
Re: scopeblock calculation
Reply #3 - Jan 31st, 2015 at 8:48pm
Print Post  
Hank45 wrote on Jan 31st, 2015 at 10:00am:
Cat_Whisperer, when you write measure the two diameters do you mean the barrel diameters where the scope blocks are being placed? Thanks for your answer, Hank45


yup.
  
Cat Whisperer (trk)
Chief of Smoke
Pulaski Coehorn Works and Skunk Works
Drafted May 1970, Retired Maj. U.S.Army
assra #9885
Back to top
WWW  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7028 seconds.