ASSRA Forum › General › General Discussion › help needed
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) help needed (Read 8621 times)
Lumpy Grits
Participating Member
*
Offline



Posts: 47
Location: Springfield, Missouri  U.S.A.
Joined: Mar 14th, 2014
Re: help needed
Reply #15 - Dec 27th, 2014 at 8:36pm
Print Post  

Don't be afraid to use 3F Goex in either the .45-70 or 90.
It's all I use with a PJ Creedmoor GG bullet.
LG
  
Hav'n you along, is like loose'n two good men
Back to top
 
IP Logged
 
John Boy
Ex Member


Re: help needed
Reply #16 - Dec 27th, 2014 at 10:09pm
Print Post  
Jeff, you 1st have to know the 200yd MOA setting that puts a bullet on the target.  This is called a base line MOA setting.
Next go to the trajectory table provided on the thread.   
If YOUR 200yd base line is more or less ... then add or subtract the difference from the 24 MOA #200yds and then add to the MOA @ 1000yds in the trajectory table.  This should put you on the paper and then fine tune your MOA.
Remember ... at 1000yds, 1 MOA = 10 inches
  
Back to top
 
IP Logged
 
Flyer
Ex Member


Re: help needed
Reply #17 - Dec 31st, 2014 at 11:38am
Print Post  
Assuming that your "sight radius" is at of near 36 inches, and using your 100 yard setting, you will need to go up on the rear sight close to 2 inches to reach 1000 yards. Assuming you are at or near 1300 fps.
Just hold center and trust your spotter!
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.4125 seconds.