ASSRA Forum › General › Reloading the Single Shot Rifle › new lube pump thread
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic new lube pump thread (Read 1639 times)
oughtsix
Global Moderator
ASSRA Board Member
*****
Offline



Posts: 1358
Location: Columbus
Joined: May 31st, 2009
new lube pump thread
Nov 15th, 2014 at 5:06pm
Print Post  
I had been told this was a Dell,  but it has no acorn trademark,   any idea who made it?  It has a small set screw  on the other side to change the die.   
  
Life Member ASSRA, OGCA &  TSGC
I'm all in favor of keeping dangerous weapons out the hands of fools. Let's start with typewriters........ Frank Lloyd Wright
Back to top
 
IP Logged
 
Green_Frog
Frequent Elocutionist
*****
Offline


"It ain't easy being green"
ASSRA Life #281

Posts: 4160
Location: Lynchburg, VA
Joined: Apr 18th, 2004
Re: new lube pump thread
Reply #1 - Nov 15th, 2014 at 7:08pm
Print Post  
This one follows the same general concept as Charlie's which was an adaptation of Pope's which was an adaptation of a West Coast design credited to Chick Martines (sp??)  There are several distinctions between this one and Charlie's design, so it is certain that this didn't come from him, hence no chinquapin acorn stamp.  Somebody made a workable interpretation of the design based on what they had to work with.  BTW, another commercial effort at the lube pump was made by Andela Tool Works back in the '70s to '80s or so... yet another design.

Froggie
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2183 seconds.