USCRA, I have a 107 and a couple of the 44's that have the breech and lever pins that screw in from one side rather than being held by keys and separate screws. All three rifles have the 7:00 extractors. The 107 is in the low 2XXX serial range, the 44's in the 10,XXX-11,XXX ranges. The 107 frame has a blotchy case-hardening pattern, like a Winchester. Only one of the 44's has traces of original finish, but it is the wavy pattern that one normally associates with Stevens. The block and lever screws for the 107 are 0.228" in diameter, with a 0.282" screw head, while those for the 44's are 0.287" with a 0.312" screw head. Evidently, some beefing up was deemed necessary as the Ideal rifle continued in use. I don't know when this started, though. The fitting of the breechblock against the back of the frame in the 107 is noticeably closer than on the 44's. Perhaps the Engineering Dept thought the heavier pins would obviate the need for close (i.e., hand) fitting on the later production. My 107's buttstock does not have the same serial number as the frame, but it does have one, in pencil under the buttplate. It has a homemade forend, or at least home-modified, worse luck, as any number on that is long gone. They must have dropped the numbering of buttstocks fairly quickly; I have seen no penciled numbers on any of my 44's. No idea when the stock replacement and modification was made, either. Anyway, you might check for some of these early Ideal features in your rifle. HTH.
|