ASSRA Forum › General › Reloading the Single Shot Rifle › Bullet mould index
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Bullet mould index (Read 1157 times)
Dales
Senior Forum Member
****
Offline



Posts: 311
Location: Western NY
Joined: Oct 21st, 2013
Bullet mould index
Feb 8th, 2014 at 10:01pm
Print Post  
How do you index your bullets?
Just broke in a new Hoch mould and have been trying to index using cut off mark , but not always clear.
Not sure that I want to put a dent in a new mould. What is the excepted way used by most casters?

Thanks Dales
  
Back to top
 
IP Logged
 
JLouis
Frequent Elocutionist
*****
Offline



Posts: 10625
Joined: Apr 8th, 2009
Re: Bullet mould index
Reply #1 - Feb 8th, 2014 at 10:21pm
Print Post  
Light punch mark on the nose and no more than what is needed to see it. I like mine up about 1/8 to 3/16 up from the first band depending on how sharp the nose is.

JLouis
  
" It Is Better To Now Have Been A Has Been Than A Never Was Or A Wanna Be "
Back to top
 
IP Logged
 
frnkeore
Frequent Elocutionist
*****
Offline



Posts: 7278
Location: Central Point, OR 97502
Joined: Jun 16th, 2010
Re: Bullet mould index
Reply #2 - Feb 8th, 2014 at 10:37pm
Print Post  
I put the marks 1/8" or less up from the point, depending on the ogive shape. It is a point of imbalance and the closer you can get it to the center, the less effect it will have on center of gravity.

That said, I only mark bullets that are .001 or more, out of round. If it nice and round, don't mark it.

Frank
  
ASSRA Member #696, ISSA Member #339
Back to top
YIMAIM  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5190 seconds.