ASSRA Forum › General › Reloading the Single Shot Rifle › Case Trimmers
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Case Trimmers (Read 7038 times)
broken_arrow
Full Member
***
Offline



Posts: 202
Location: Lancaster County
Joined: Aug 12th, 2008
Re: Case Trimmers
Reply #15 - Feb 7th, 2014 at 8:06am
Print Post  
Thanks for the responses.
I have purchased a Forster trimmer, holders, and pilots from a member here.
After looking at them all, I think the Forster will do the most of my needs for the least of my money.
I'll find out soon.
Thanks again,
Dave
  
ASSRA #10186 (10-25-2021)
Every Mighty Oak Was Once A Little Nut That Held Its Ground
Back to top
 
IP Logged
 
argie1891
Senior Forum Member
****
Offline



Posts: 267
Location: selah, washington
Joined: Jul 8th, 2010
Re: Case Trimmers
Reply #16 - Feb 8th, 2014 at 3:28am
Print Post  
when I have to trim a lot off each case I mark with a felt tip pen and cut them off close in my metal lathe. then I use a lyman trimmer in my drill press. I used Forester and lyman bench models for a long time, but if you have access to a metal lathe it only takes a second or to and you have them cut close to the correct length.
  
if you think you have it figured out  then you just dont understand
Back to top
 
IP Logged
 
Irascible
Senior Forum Member
****
Offline



Posts: 279
Location: Pleasant Valley
Joined: Apr 6th, 2007
Re: Case Trimmers
Reply #17 - Feb 9th, 2014 at 11:58am
Print Post  
When working with my 45-70 and 40-65 BP guns, I noticed I was getting slightly different length cases when trimming with my Forster. I tracked down the problem which was caused by a difference in rim diameter used in a collet type trimmer. This caused a slight difference in case position and trim length. I switched to a new RCBS which indexes off the FRONT of the rim giving identical trim lengths. So my recommendation would be to avoid collet type trimmers. It's also a lot faster, even without the motor drive. Although I installed an allan screw where the crank used to be and use a bit in my electric screwdriver to turn it.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4292 seconds.