ASSRA Forum - Martini ? Forgive me but now I am really confused

ASSRA Forum › General › Single Shot Rifles › Martini ? Forgive me but now I am really confused

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1 [2]

Martini ? Forgive me but now I am really confused (Read 11043 times)

Mal Full Member Offline Posts: 238 Location: Adelaide SOUTH AUSTRALIA Joined: Dec 5^th, 2012	Re: Martini ? Forgive me but now I am really confused Reply #15 - Jan 29^th, 2014 at 3:36am	Print Post
	G'day, Hi from Aus. I run a cadet in .308/.222 , breach seated it will print under or on 1"@100yds,311644bv lyman mold, 25/1 9grns Unique, also Rcbs .30-180-fn ditto,Am in the process of doing a .30/30 Wesson or similar using the .357Maxi case , full length tapered to .30cal,the .308/.222 case is a bugger to form, hope the .357maxi should be easier ,Have also Jamed 35gns Goex 2ff in the case , showing some promise, We shoot a 100yd match off hand on the old cast iron German Target,BP only App , sights quite a hard match, but lots of fun!!The cadet is very popular in Aus .I also run a .357mag as well, Cheers Mal.


	IP Logged

EdBu Full Member Offline Posts: 108 Location: SW Washington Joined: Jan 13^th, 2008	Re: Martini ? Forgive me but now I am really confused Reply #16 - Jan 29^th, 2014 at 9:40pm	Print Post
	Muddy; I got minute of bowling pin offhand with my 32 Special cadet with a Lyman 438 scope at about 50 yards. I loaded the empties with a bit of Unique, and some CBE cadet bullets. I have not shot these yet. I also have some DKT 100 grain cadet bullets that are quite accurate in my 310's. I have not used those Rapine bullets, and I do not cast. Could you spare a few? Ed


	IP Logged

Pages: 1 [2]

‹ Previous Topic | Next Topic ›

Page completed in 0.9280 seconds.