ASSRA Forum › General › Single Shot Rifles › How to remove barrel on 44 1/2?
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) How to remove barrel on 44 1/2? (Read 10747 times)
UtahDave
Senior Forum Member
****
Offline



Posts: 396
Location: Heber City, Utah
Joined: Aug 14th, 2010
Re: How to remove barrel on 44 1/2?
Reply #15 - Jan 26th, 2014 at 10:43am
Print Post  
And when reassembling if you put a small wooden dowel in the lever pin hole it will hold the extractor in place. Just make the dowel  shorter than the block width.  Push out the dowel with the metal lever pin.   

Dave
  
Back to top
 
IP Logged
 
Bulseyetom
Frequent Elocutionist
*****
Offline



Posts: 1046
Location: Santa Maria, Ca
Joined: Oct 31st, 2010
Re: How to remove barrel on 44 1/2?
Reply #16 - Jan 26th, 2014 at 6:40pm
Print Post  
Thanks guys for the wealth of information!   Smiley
  
Back to top
Twitter  
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.6362 seconds.