ASSRA Forum › General › Collecting Single Shot Rifles › 1873 Maynard in 40-70 Caliber
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 2 3 [4]  Send TopicPrint
Very Hot Topic (More than 25 Replies) 1873 Maynard in 40-70 Caliber (Read 32406 times)
xtimberman
Full Member
***
Offline



Posts: 172
Location: N. Texas
Joined: Mar 26th, 2010
Re: 1873 Maynard in 40-70 Caliber
Reply #45 - Aug 23rd, 2013 at 5:41pm
Print Post  
FYI...this is how the Mass. Arms factory fitted Marlin-Ballard sights with a 3/8" dovetail to the 30/64" cut on Maynard barrels.

(You need to Login or Register to view media files and links)

If you look closely, you can see the larger shim carefully milled for the purpose.

Here is a short segment of a strip of 3/8" to 30/64" shim stock I made up (back when I had access to a mill) to fit Ballard sights onto some Maynard rifles:

(You need to Login or Register to view media files and links)
« Last Edit: Aug 23rd, 2013 at 5:49pm by xtimberman »  
Back to top
 
IP Logged
 
rustyrelx
Senior Forum Member
****
Offline



Posts: 474
Location: Wallace Idaho
Joined: Oct 9th, 2007
Re: 1873 Maynard in 40-70 Caliber
Reply #46 - Aug 28th, 2013 at 9:42pm
Print Post  
Sights were made for Marlin... not by Marlin, by the Bridgeport Gun Impliment Co as were many of the Ballard parts as well as for the Sharps Rifle Co.. The rear barrel sight in question looks like a Winchester, not a Ballard at all. Winchester and Stevens both used serrated edges on their sights Marlin did not. Elevator is totally different on a Ballard also. Don
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 2 3 [4] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2085 seconds.