ASSRA Forum - How to disassemble maynard action

ASSRA Forum › General › Collecting Single Shot Rifles › How to disassemble maynard action

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1 [2]

How to disassemble maynard action (Read 9601 times)

Green_Frog Frequent Elocutionist Offline "It ain't easy being green" ASSRA Life #281 Posts: 4066 Location: Lynchburg, VA Joined: Apr 18^th, 2004	Re: How to disassemble maynard action Reply #15 - May 13^th, 2013 at 5:38pm	Print Post
	Captain Bob, you wouldn't perchance be located in or near WC Fields' favorite city, Philadelphia, would you? It took me a minute to figure out who you might be, but I think I've got it now. How do we keep missing each other @ Yeck's each Nationals?? Did you ever get that Maynard re- and decapper for your 25-20 yet? Hope to see you this weekend. Froggie


	IP Logged

Captain Bob Junior Member Offline Posts: 86 Joined: Mar 27^th, 2013	Re: How to disassemble maynard action Reply #16 - May 13^th, 2013 at 7:32pm	Print Post
	Froggie - you got me figured out right down to my shoe laces. Still checking in at @ Yeck's Maynard Roundtable couple three times every day at every National but haven't pulled up a chair the past several shoots; usually just looking for Bly or Cockey to see what's new. I'll plan on lingering a little bit longer and perhaps we'll meet up. No, still have not found a Hadley re&de but keep looking. Three or so Nationals ago I finally found an original Maynard tool, just before the OK repros showed up. Did pull a Mass Arms 40 cal mold off eBay a few weeks ago - two sharp bright #1 cavities - nice. Have hopes for it with my 40-70 1882. I got sniped on a very nice looking 50 single cavity just before the 40 cal went off; was so mad paid too much for the 40, but what are you gonna do. So stay well, I'll look for you this weekend - drive carefully... Bob


	IP Logged

Pages: 1 [2]

‹ Previous Topic | Next Topic ›

Page completed in 0.6503 seconds.