ASSRA Forum › General › Collecting Single Shot Rifles › Stevens 417 1/2 forearm dimensions needed
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Stevens 417 1/2 forearm dimensions needed (Read 2144 times)
wthw
Participating Member
*
Offline



Posts: 10
Location: jamaica
Joined: Sep 29th, 2008
Stevens 417 1/2 forearm dimensions needed
Apr 5th, 2011 at 8:37pm
Print Post  
Can anyone tell me what the thickness/width of the 417 1/2 forearm is at the rear of the forearm where it meets the front of the frame?  I recently purchased a 417 1/2 with a refinished (poorly and with a handstop rail inlet into it) forearm.  Perhaps it would be better to ask how proud the wood should stand on each side of the frame (I believe it should be flush on the bottom)?  This one is about flush and uneven while my 417 forearm stands proud by a good 3/32" on each side.  Any help will be greatly appreciated.
  
Back to top
 
IP Logged
 
slumlord44
Frequent Elocutionist
*****
Offline



Posts: 2850
Location: Lebanon, Illinois 62254
Joined: Dec 21st, 2007
Re: Stevens 417 1/2 forearm dimensions needed
Reply #1 - Apr 6th, 2011 at 11:10pm
Print Post  
The stock on my 417 1/2 .22 Hornet is 1/32 proud from the frame. I am certain that the stock has never been touched. Hope this helps
  
Back to top
 
IP Logged
 
MAD MIKE
Oldtimer
*****
Offline



Posts: 655
Location: So Cal
Joined: Oct 31st, 2006
Re: Stevens 417 1/2 forearm dimensions needed
Reply #2 - Apr 7th, 2011 at 1:58am
Print Post  
Mine's about 1/16", the sides flair out about 1 3/4"in a concave arc & the bottom bellies down about 1/8".      Good luck,    ...MIKE...
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.3471 seconds.