ASSRA Forum › General › Reloading the Single Shot Rifle › Lee Shaver grease ribbon extracter
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Lee Shaver grease ribbon extracter (Read 1603 times)
Van
Senior Forum Member
****
Offline



Posts: 251
Location: Uath
Joined: Oct 25th, 2005
Lee Shaver grease ribbon extracter
Feb 16th, 2011 at 11:27pm
Print Post  
years ago I bought one of the grease cookie ribbon thingies and I have a friend that wants me to make him some grease ribbon for his 45-100, only problems is I can't remember how it installs in the lubersizer. 

I know it must be simple but I just can't remember. 

Can someone help me on this? thanks in advance on any help....van
  
Back to top
 
IP Logged
 
Hank45
Oldtimer
*****
Offline


Beer is living proof that
GOD loves you

Posts: 506
Location: MA
Joined: Jan 21st, 2010
Re: Lee Shaver grease ribbon extracter
Reply #1 - Feb 17th, 2011 at 2:50pm
Print Post  
Van, I had one of these grease ribbon extractors a few years back and if I remember right you screwed the extractor into the press after you removed the shell holder and in the shell holders place you put a coin so that the rod that pushed the grease out had something to push against, I hope this helps you, Hank
  
Back to top
 
IP Logged
 
Van
Senior Forum Member
****
Offline



Posts: 251
Location: Uath
Joined: Oct 25th, 2005
Re: Lee Shaver grease ribbon extracter
Reply #2 - Feb 17th, 2011 at 10:03pm
Print Post  
got it figured out, thanks
van "the old man"
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0420 seconds.