ASSRA Forum › General › Reloading the Single Shot Rifle › Homemade Bullet Molds
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Homemade Bullet Molds (Read 19241 times)
Cat_Whisperer
Frequent Elocutionist
*****
Offline


No 1, 9.3x74R

Posts: 3877
Location: Mountains of Virginia
Joined: Apr 17th, 2004
Re: Homemade Bullet Molds
Reply #15 - Dec 27th, 2010 at 9:19pm
Print Post  
COOL process.
Not unlike how bearing shell inserts are made - where 0.0001"s are important.
  
Cat Whisperer (trk)
Chief of Smoke
Pulaski Coehorn Works and Skunk Works
Drafted May 1970, Retired Maj. U.S.Army
assra #9885
Back to top
WWW  
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4890 seconds.