ASSRA Forum › General › Reloading the Single Shot Rifle › Reloading .50-45
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Reloading .50-45 (Read 12113 times)
nobearsyet
Ex Member


Re: Reloading .50-45
Reply #15 - Dec 6th, 2010 at 11:13am
Print Post  
AmI the only one that buys his brass at Midway?  I have found they have most of the uncommon, or dare I say, "obsolete" stuff either in stock or available by special order.
  
Back to top
 
IP Logged
 
bluelake
Ex Member


Re: Reloading .50-45
Reply #16 - Jan 16th, 2011 at 12:23pm
Print Post  
I'm becoming a bit frustrated with reloading this caliber.  I keep on finding such-and-such won't work.  Every time I seem to fix one problem, another one pops up.  The current one is that the hand auto primer that came with my Lee reloading press will not accommodate .50 cal. brass.  Suggestions?


  
Back to top
 
IP Logged
 
38_Cal
Frequent Elocutionist
*****
Offline



Posts: 2247
Location: Montezuma, Iowa
Joined: Apr 27th, 2005
Re: Reloading .50-45
Reply #17 - Jan 16th, 2011 at 1:11pm
Print Post  
Depending on where I'm at when I have cases to prime, I use either an RCBS bench type tool that uses standard shell holders, an RCBS hand tool or a Pete Allan copy of the Pope tool, also using RCBS shell holders.  Take a look on EvilBay for the priming tools...good used RCBS tools are going for about $10 and up.  My two RCBS tools work well with my 577-450 shell holder, as well as "normal" sized shell holders.

David
  
David Kaiser
Montezuma, IA
Back to top
 
IP Logged
 
bluelake
Ex Member


Re: Reloading .50-45
Reply #18 - Jan 16th, 2011 at 4:38pm
Print Post  
Thanks, 38_cal--I put a bid on an RCBS bench model.   
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1002 seconds.