ASSRA Forum › General › General Discussion › Sawmiller egraving sample
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Sawmiller egraving sample (Read 2592 times)
KAF
Ex Member


Sawmiller egraving sample
Dec 14th, 2008 at 4:53pm
Print Post  
Mike's work

  
Back to top
 
IP Logged
 
KAF
Ex Member


Re: Sawmiller egraving sample
Reply #1 - Dec 14th, 2008 at 4:57pm
Print Post  
Again
  
Back to top
 
IP Logged
 
KAF
Ex Member


Re: Sawmiller egraving sample
Reply #2 - Dec 14th, 2008 at 5:10pm
Print Post  
Roller
  
Back to top
 
IP Logged
 
38_Cal
Frequent Elocutionist
*****
Offline



Posts: 2247
Location: Montezuma, Iowa
Joined: Apr 27th, 2005
Re: Sawmiller egraving sample
Reply #3 - Dec 14th, 2008 at 5:27pm
Print Post  
Thanks!  Lots better than I can even dream of doing!  One question...where did he get that left hand Roller that's so nicely engraved?   Grin Shocked

David
Montezuma, IA
  
David Kaiser
Montezuma, IA
Back to top
 
IP Logged
 
acelungger
Ex Member


Re: Sawmiller egraving sample
Reply #4 - Dec 15th, 2008 at 9:00pm
Print Post  
I don't know who Mike is, but he does AWESOME work! Mike if you read this, my hat is off to you!
ACE
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1662 seconds.