ASSRA Forum › General › General Discussion › SCOPE ADAPTER
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) SCOPE ADAPTER (Read 9448 times)
joeb33050
Frequent Elocutionist
*****
Offline



Posts: 2613
Location: Marathon, FL
Joined: Apr 20th, 2004
Re: SCOPE ADAPTER
Reply #15 - Sep 16th, 2008 at 10:19am
Print Post  
Quote:
Joe
Why dont u want the barrel drilled? 
that would be the best solution to ur problem. Or u could make a sleeve and braze a block to it. I have a Remington scope designed to mount on the receiver. Unertl made one also. they will cost u as much as a good modern target scope. u have more scopes to choose from if u use the receiver mts. I like the redfield and buris one piece bases. 
Lots of luck
Tom

Why? Mail gun to gunsmith = $28, gunsmith charge $30, mail gun back to me $28. $86 total for hole drilling.
joe b.
  
Back to top
 
IP Logged
 
screwloosetc
Ex Member


Re: SCOPE ADAPTER
Reply #16 - Sep 16th, 2008 at 11:43am
Print Post  
Joe 
For what is the purpose are u buying this rifle? if u are going to compete with it the scope mt. isn't ur only problem. Spend some time at benchrest centeral. Ebay has a lot of receiver mt. target scopes in the $100 range that will work just as well if not better than the lyman.
Tom
  
Back to top
 
IP Logged
 
deadwooddick
Full Member
***
Offline



Posts: 105
Location: Deadwood
Joined: Mar 10th, 2008
Re: SCOPE ADAPTER
Reply #17 - Sep 17th, 2008 at 10:34am
Print Post  
I did the same on a Haenel KK Sport 22LR… but I used the Lyman 20MJT as the globe is LARGER. Using the Shaver insert(s)… good stuff.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4322 seconds.